- 您现在的位置：买卖IC网 > Sheet目录506 > SD101201 (Cherry)SENSOR GEARTOOTH SPEED PLASTIC
GEARTOOTH SPEED
AND DIRECTION SENSOR
SD1012 Series
Hall-effect geartooth speed and direction sensor with adjustable aluminum or ?ange-mount plastic housing.
Features
? Sense speed and direction of ferrous geartooth targets
? Plastic ?ange mount sensor rated to 125 °C
? Near zero speed sensing capability
? Capable of 8000+ Hz target speed
? 10 bit dynamic threshold detection offers:
- Automatically adjusting magnetic range
- Self compensating to target geometry
- Immune to target run out
? Compatible with unregulated power supply
? Reverse battery protected to -30 V DC
? Internal circuit protection to IEC529 1,000
- EMI resistant to 10 V/m, 30 MHz to 1 GHz
- ESD resistant to 4 kV (Contact discharge)
- Fast transient resistant to 2 kV
- Conducted immunity resistant to 10 VRMS@150 kHz to 80 MHz
- EMC compatible 30 A/m @ 50 Hz
Speci?cations
? Meets IEC60529 IP67 for dust and water protection
- Integral Connector version: 4-pin
Delphi Metri Pack 150.2 No. 12162833.
Mates with Terminal No. 12124075.
- Discrete wire version: 20 AWG, PVC insulation, UL1007/1569
Applications
? Wheel speed and direction
? Transmission speed and direction
? Hoist speed and direction
Operating
Supply
Output
Output
Operating
Storage
Housing
Part Number
Voltage Range
Current
Output
Saturation Voltage
Current
Temp Range
Temp Range
Material
(VDC)
(mA max.)
(mV max.)
(mA max.)
(°C)
(°C)
SD101201
4.75 – 24
20
sink
1000
20
– 40 to 125
– 40 to 125
Plastic
Notes: SD101201 uses Delphi Metri-Pack 150.2 Series Part No. 12162833. Mating terminal: Delphi Part No. 12124075.
A pull up resistor is required between power and each output. Resistor value is dependent upon input voltage. See page 27 for recommendations.
Dimensions
inches (mm)
All tolerances ±0.005 (0.13) unless otherwise noted.
3.0 (76.2)
1.92 0.009
(48.79 0.25)
0.25 (6.35)
R 0.468 (11.88)
0.976
(24.8)
0.511
(13.0)
SD101201
? 0.703 0.005
(17.86 0.13)
Regulator
Magnet
V Reg
V Reg
Conditioning
Logic
C VCC (brown)
Pull-up
B Resistor Speed
A (black) Direction
(white)
D Ground
(blue)
18
Pin A (Direction Output)
Pin B (Speed Output)
R 0.128 (3.25)
0.181 (4.6)
Speci?cations subject to change without notice.
Pin D (Ground)
Pin C (Power)
R 0.010 (7.25)
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
SDP8407-001
PHOTOTRANSISTR SILICON NPN
SDP8436-004
PHOTOTRANSISTOR SILICON NPN T-1
SDP8476-201
PHOTOTRANSISTOR NPN SIDE LOOK
SE2460-002
DIODE IR EMITTING GAAS PILL PACK
SFP-1GBT-05
OPTO FIBER OPTIC TRANSCEIVER
SFP-1GBT-06
OPTO FIBER OPTIC TRANSCEIVER
SFP9530
MOSFET P-CH 100V 10.5A TO-220
SFT1341-E
MOSFET P-CH 40V 10A TP
相关代理商/技术参数
SD1012-03
制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:RF & MICROWAVE TRANSISTORS
SD1013
功能描述:射频放大器 RF Bipolar Trans RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel
SD1013-03
功能描述:射频放大器 RF Bipolar Trans RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel
SD10-131J
制造商:Kahgan Electronics Corp. 功能描述:CAPACITOR, MICA, 500 V, 130 PF, THROUGH HOLE MOUNT
SD1013-3
制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:RF MICROWAVE TRANSISTORS 108-152 MHZ APPLICATIONS
SD1014
制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:RF & MICROWAVE TRANSISTORS
SD1014-02
制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:RF & MICROWAVE TRANSISTORS
SD1014-06
制造商:ADPOW 制造商全称:Advanced Power Technology 功能描述:RF & MICROWAVE TRANSISTORS VHF MOBILE APPLICATIONS